Rolling Steel Door Repair is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Rolling steel service doors, curtains, guides and springs repaired.
Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.
Signs you need rolling steel door repair
- The curtain is jammed or crooked in the guides
- Bent slats or bottom bar
- The door is hard to raise by hand or chain
- The operator runs but the door doesn't move
Why this happens
- Impact damage to slats or guides
- Loss of spring tension in the barrel
- Worn operator components
What you can check yourself
- Don't keep forcing a jammed curtain.
- Look for bent guides near the floor.
Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.
Our rolling steel door repair process
- Inspect the curtain, guides, barrel and operator
- Replace damaged slats or the bottom bar
- Adjust the spring tension in the barrel
- Repair the operator
- Test the full travel
Typical rolling steel door repair prices
What moves the price:
- Door size, gauge and cycle rating
- Operator type and controls
- Parts availability for your model
- Lift equipment and after-hours access
These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.
Serving Mitchell, SD and nearby towns
Road salt and meltwater dripping off vehicles rust the bottom of tracks, cables and roller stems, which is why cable and roller failures in South Dakota usually start at floor level.
Besides Mitchell (ZIP code 57301), we handle rolling steel door repair in Huron (46.1 mi), Madison (50 mi), Hartford (54.7 mi) and Lennox (62.1 mi). Call (833) 435-8883 to book a visit in Mitchell.
Rolling Steel Door Repair: frequently asked questions
How much does rolling steel door repair cost in Mitchell, SD?
Rolling Steel Door Repair typically costs $300-$1,500 including parts and labor, and usually takes 2-4 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.
Can you do rolling steel door repair the same day?
Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.
Is rolling steel door repair covered by a warranty?
Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.
Are your technicians licensed and insured?
Our technicians are insured, and where South Dakota or Mitchell requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.
Should I repair or replace my commercial door?
A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.